Gospell Encorder Configuration
As we all know most of low budget headends are of Gospell. These headends are widely using by indian MSOs because of it low price range.
Today in this session we will tell you about How To Configure GN-1838 8 Channel Encoder and It is very easy to configure these Encoders.
Follow the steps for Gospell Encoder Configuration for GN-1838,
Login into Encoder first then go to Device Management TAB then we need to do OFF the MUX STATUS because we are using here SPTS (Single Program Transport Stream).
Now we need to go to Output Parameter Tab and then open Output Parameter. Select SPTS (Single Program Transport Stream) and then select UDP (User Datagram Protocol).
As you can see below in image we need to put different multicast for each channel. UDP will be same as shown in image below,
Now go to IP Output Parameter and set Encoder Output Bitrate 38000 Kbps or 38 Mbps. As shown in image below,
Now go to Program Parameter TAB and then go to Program 1-4 Parameters. Now set your Service names as well as SID (Service ID). Then set service names and SID for Program 5-8 Parameters. As shown in image below,
Now we need to set Video Bitrate as much you want. We have given 4Mbps per channel. As Shown in image below,
Now you can check your multicast IP Address at output for 8 channels. If you are having any problem then let us know by commenting below the article.